tinQer.ai is the in-browser agent for embedded and IoT development. Describe what you want to build — the agent writes the firmware, runs it in a live hardware simulator, and ships it to your device in one click.
Every project flows through the same loop — and the same chat goes with it the whole way.
Tell the agent what device behavior you want. It picks a framework, writes the firmware, and runs it in a live hardware simulator — LEDs, GPIO, I²C, UART, sensors.
Move from breadboard to board. The agent proposes a bill of materials, picks footprints, and drafts a schematic that matches the firmware it already wrote.
Send the design to a fab partner, set up secure provisioning, and define the OTA channel — all in the same project.
Most AI coding tools think the world ends at a unit test. tinQer.ai knows there's a board on the other side.
AGENTS.md, PROJECT.md, and wing.json live in every project — the agent reads them, follows them, and edits them as your product evolves.
LEDs that light up. Pins that pulse. Buses that talk. See your firmware behave before flashing — and replay the timeline when something looks off.
No toolchain to install, no esptool incantations. Plug in a board over USB, hit Flash to device, watch logs stream in.
The agent watches the serial monitor. When something asserts, panics, or just behaves wrong, it proposes the fix without you copy-pasting the trace.
ESP-IDF, Zephyr, Arduino, PlatformIO. Pick your stack — the agent adapts its toolchain, build system, and component conventions.
Secure boot, per-device keys, signed OTA. Wired in at the Manufacture stage, not bolted on weeks before audit.
Private beta is open to a small cohort of embedded devs and hardware teams each week.